cnc_rotary
**This is an old revision of the document!**
Table of Contents
Design/Toolpath
Job Setup
- X-Y datum is CENTER of material
- orientation is along the Y axis
- calculate roughing and finishing cuts as normal
- 3D-raster at 90-degrees
- that way less rotation, more travel along the Y, should be faster
- when saving toolpaths select the “Axiom HHC CNC 4TH” post-processor
- this is how the X axis motion is translated into A axis rotation
Material Prep
- rough to diameter + a couple mm
- mark center line on piece
- measure center end-to-end for finding XY=0
- touch-off puck Z to metal bed
- then +Z to 75mm and re-zero
- or create a 75mm block to use for Z-axis 0-ing
cnc_rotary.1737400165.txt.gz · Last modified: 2025/01/20 19:09 by ron