woodworking:woodturning:vicmarcjaws
Vicmarc Jaw Ranges (on a VM120 chuck)
| Type | Name | ID-min | ID-max | OD-min | OD-max |
|---|---|---|---|---|---|
| Dovetail | standard | 48 | 90 | 68 | 116 |
| Dovetail | 85mm | 63.5 | ? | 85 | ? |
| Dovetail | 105mm | 84 | 123 | 105 | 152 |
| Dovetail | 128mm | 106 | ? | 128 | ? |
| Dovetail | 148mm | 126 | 165 | 148 | 196 |
| Dovetail | 173mm | 150 | ? | 173 | ? |
| Dovetail | 198mm | 175 | ? | 198 | ? |
| Dovetail | 223mm | 199 | 237 | 223 | 272 |
| Long-nose | 30 | ? | 47 | ? | |
| Pin | 25mm | ? | ? | 25 | ? |
| Pin | 35mm | 6 | 37 | 35 | 64 |
| Shark | 55mm | 35 | 78 | 55 | 102 |
| Shark | 68mm | 48 | 90 | 68 | 115 |
| Shark | 83mm | 65 | 93 | 83 | 116 |
| Shark | 105mm | 87 | ? | 105 | ? |
| Shark | 130mm | 110 | ? | 130 | ? |
| Step | 111 | 149 | 127 | 175 | |
| Step | 97 | 136 | - | - | |
| Step | 70 | 110 | - | - | |
| Step | 50 | 92 | - | - |
Notes
- - = not-applicable (mostly for step which only has 1 outside diameter range but 4 inside diameter ranges)
- ? = don't have the chuck so measurements given are from Vicmarc's site
- all measurements in millimeters
- where measurements didn't match Vicmarc posted sizes Vicmarc's measurements were used
- typically 2mm bigger
woodworking/woodturning/vicmarcjaws.txt · Last modified: 2025/06/24 23:50 by ron